Adaptor base to accept PL10 type point motors for either above or below base board use, includes an over centre spring, as fitted to all Peco turnouts.

1. If it is wished to fit the turnout motor above the baseboard, rather than below, then the adaptor base is used. An extension arm included allows the motor to be positioned up to 40mm away from the track. The point's over centre spring has to be removed as that in the base takes over. The whole unit, including motor, can be disguised by placing a small building, such as an LK-4 Lineside Hut, over it.

2. If the modeller wishes to power non-PECO points which do not have the over centre spring action. The adaptor base is positioned underneath the point and the PL-10E is attached to it, allowing the the point to be operated as if it were PECO.

1. If the modeller wisheds to mount the turnout motor above the baseboard, rather than below, then the adaptor base is used. An extension arm included allows the motor to be positioned up to 40mm away from the track. The point's over centre spring has to be removed as that in the base takes over. The whole unit, including motor, can be disguised by placing a small building, such as an LK-4 Lineside Hut, over it.

2. If the modeller wishes to power non-PECO points which do not have the over centre spring action. The adaptor base is positioned underneath the point and the PL-10 is attached to it, allowing the the point to be operated as if it were PECO.